|
|
|
|
|
|
Heather Harp TM Nylon Case
|
Sale Price: $65.90
Today's Web Special: $49.43
|
|
|
Nylon padded quilt carrying case for storage or travel. back side: 32.5" long Pillar Side: 35" Tuning Arm: 20" bk-pillar x 4" wide Foot: 7.5" bk-pillar x 10.25 " wide
|
|
|
|
|
|
|
|
|
|
Heather Harp TM Hard Case
|
Sale Price: $133.90
Today's Web Special: $100.43
|
|
|
Cloth covered hard sides, latches, and felt interior protect the Heather Harp during storage and travel. Inside dimensions: Harp base area: height 9.5" x width 8.75"; Harp arm area: 21.75"latch to hindge x 4.75" side to side; Harp back area ( hinge side) length = 35"; Harp arm area (latch side) length= 37.5".
|
|
|
|
|
|
|
|
|
|
Minstrel Harp TM Nylon Case
|
Sale Price: $73.90
Today's Web Special: $55.43
|
|
|
Nylon padded quilt carrying case for storage or travel.
|
|
|
|
|
|
|
|
|
|
You CAN Play the Harp!
|
Sale Price: $10.90
Today's Web Special: $9.81
|
|
|
By Victoria Lynn Schultz. 101 pages of detailed instructions, illustrations and music for the beginning harp student.
|
|
|
|
|
|
|
|
|
|
Mel Bay's Basic Harp for Beginners
|
Sale Price: $12.99
Today's Web Special: $11.69
|
|
|
By well known performer and teacher, L. Riley. 77 pages include tuning, finger placement, reading music, 10 songs glossary, and much more.
|
|
|
|
|
|
|
|
|
|
Pixie Harp TM Nylon Case
|
Our Price: $53.90
Sale Price: $40.43
|
|
|
Nylon padded quilt carrying case for storage or travel.
|
|
|
|
|
|
|
|
|
|
Heather Harp TM Nylon String Set
|
Sale Price: $18.90
Today's Web Special: $17.01
|
|
|
22 DuPont hard nylon strings, color coded for easy replacement, red for C and blue for F.
|
|
|
|
|
|
|
|
|
|
Harp Tuning Pins, 2 5/8", Pack of 6
|
Our Price: $11.90
Sale Price: $10.71
|
|
|
Harp Tuning Pins, Pack of 6. These tuning pins are meant to fit the Pixie Harp (TM), Heather Harp (TM), and Minstrel Harp (TM). They are approximately 2 3/8 to 2 5/8 inches long. These pins are hand made so expect some variation in size. The pegs are tapered so to change your tuning pin, remove the string and place your tuning wrench over the string end of the pin. Then tap on the wrench to tap the pin out through the harp arm. Replace the pin by inserting from the tuning side. Place the tuning wrench on the tuning end of the pin and tap it into place. The tuning ends of the pins should all be aligned. If necessary, wooden toothpicks make great shims.
|
|
|
|
|
|
|
|
|
|
Baby Harp TM Nylon Case
|
Sale Price: $37.90
Today's Web Special: $34.11
|
|
|
Nylon padded quilt carrying case for storage or travel. With strap handle and zipper pocket. The dimensions are approximate: Length along back: 18.5-19 inches
Length along Pillar 20 inches
Length along Top (tuning Arm) 12- 12.5 inches
Length along base 6-6.5 inches
Width at top (tuning arm) 1.5 inches
Width at base 6.5-7 inches
|
|
|
|
|
|
|
|
|
|
Mel Bay's Celtic Music for Folk Harp
|
Sale Price: $12.95
Today's Web Special: $11.66
|
|
|
By Riley & McMichael. Introduces Celtic style music, components, ornamentation and 28 songs, for moderate to advanced skill.
|
|
|
|
|
|
|
|
|
|
Sharpening Lever, Rivet 2 Pole 4 pk
|
Our Price: $15.90
Sale Price: $14.31
|
|
|
Sharpening Lever, Rivet 2 Pole 4 pk (Item Code: LVER-D) Pack of 4 Replacement Rivet-pivot, double pole narrow sharpening levers with shiny finish for harps. The Lever has a riveted arm that lifts to change the note of the string from the natural note to the sharp. The rivet holds the arm, but is not adjustable for tension. When the lever is down it is free of the strings. When the lever is in the up position, it is engaging the strings. These have a grooved double pole mechanism, usually used for longer and heavier strings. Measure your existing levers carefully to match the size. With the lever in the down position, measure from the anchor plate of the lever (the part screwed to the harp) to the poles. The distance to the closer, bottom pole is 9 mm. The distance to the further, upper pole is 19 mm. The over all length of the lever in the down position is 1 11/16 inches (43 mm). The length of the pole itself is 5 mm. The amount of lift, can be adjusted by pulling or pushing the bridge pin in by a 1/16 of an inch. This changes the point at which the string is engaged by the pole. You can also loosen the screw holding the lever to the harp and move the lever up or down. Again, by only a 1/16 of an inch at a time; very minor changes will have profound effects on the string’s notes. You need to supply your own 5/8 inch wood screw to attach the lever; avaliable at most hardware stores.
|
|
|
|
|
|
|
|
|
|
Sharpening Lever, Rivet Sgl Pole, 4pk
|
Our Price: $15.90
Sale Price: $14.31
|
|
|
Sharpening Lever, Rivet Sgl Pole, 4pk (Item Code: LVER-S) Pack of 4 Replacement Rivet-pivot, Single pole Shiny finish sharpening levers for harps. The Lever has a riveted arm that lifts to change the note of the string from the natural note to the sharp. The rivet holds the arm, but is not adjustable for tension. When the lever is down it is free of the strings. When the lever is in the up position, it is engaging the strings. These have a Grooved Single Pole mechanism, usually used for shorter and thinner strings. Measure your existing levers carefully to match the size. With the lever in the down position, measure from the anchor plate of the lever (the part screwed to the harp) to the pole. The distance to the pole is 8 mm. The over all length of the lever in the down position is 1 1/4 inches (34 mm). The length of the pole itself is 5 mm. The amount of lift, can be adjusted by pulling or pushing the bridge pin in by a 1/16 of an inch. This changes the point at which the string is engaged by the pole. You can also loosen the screw holding the lever to the harp and move the lever up or down. Again, by only a 1/16 of an inch at a time; very minor changes will have profound effects on the string’s notes. You need to supply your own 5/8 inch wood screw to attach the lever; avaliable at most hardware stores.
|
|
|
|
